Preparation: Clean & dry surface with wipe or mop
Mat Installation:
Remove bottom protective film(Layer Q), the adhesive side will be exposed, which can stick mat to
the floor. Do not remove the upper protective film (Layer Q) at this time.
Start by placing two corners of the mat on the floor where it is to be placed, (slightly bend mat from
opposite end, while keeping the rest of the mat from fully touching the floor). Slowly work from these
2 corners pressing from side to side across the full mat. (Process is similar to placing a sticker).
Make sure to get good adhesive contact with floor surface, appling weight by stepping on the mat.
Slowly remove "topprotective clear sheet (Layer O) this will expose (Layer ) which are
numbered sheets with adhesive op top. Starting with sheet [1]